Anycubic Heated Bed, Kobra 2 Pro

Questions & Answers about Anycubic Heated Bed

Receive answers from other customers who purchased this product. Please forward any other order-related questions to our Customer Service Team.

• Can I use one of these to replace the heatbed of my anycubic i3 mega? If so, which version would fit?

  This question has not been answered yet.

  Answer this question

• Have they fixed the thermistor wire breakage issue or are these just going to break again every 40 hours or so?

  This question has not been answered yet.

  Answer this question

• Can this hot bed be used with 24v instead of 12v?

  1 Answer, last answered on September 28 2021

  Answer this question

  • Andrew

    September 28 2021

    Customer Service

    Changing the voltage of a heated bed requires replacing the whole heating element which is a bit of a job. We would recommend getting one rated for the voltage you need to begin with.

• This is the bed only correct no glass, hardware, or clips?

  1 Answer, last answered on January 12 2021

  Answer this question

  • Andrew

    January 12 2021

    Customer Service

    Yes it is just the heated bed. The glass (ultrabase) can be found here: https://www.3djake.uk/anycubic-3d-printer-and-accessories/ultrabase-glass-plate

• Can this be retro fitted to a mega zero?

  1 Answer, last answered on January 28 2021

  Answer this question

  • Andrew

    January 28 2021

    Customer Service

    I wouldn't recommend it, its for the Mega X which is way bigger than the Mega Zero

• The blue/green plug does not show any polarity. Does the orientation of that plug on the mainboard matter? If so, what is the correct orientation?

  1 Answer, last answered on May 25 2021

  Answer this question

  • Andrew

    May 25 2021

    Customer Service

    No the polarity doesn't matter for these beds, they're essentially just big resistors :)