2 English reviews written for 3DJAKE Adheasy Spray
83 customer reviews in all languages
| 5 stars | | 161 | (84%) |
|---|---|---|---|
| 4 stars | | 20 | (10%) |
| 3 stars | | 8 | (4%) |
| 2 stars | | 1 | (0%) |
| 1 Stars | | 1 | (0%) |
Filter reviews:
-
Ivan
May 21 2025
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. Was this rating helpful? (0) (0)
-
Goran Visnjic, Slovenia
June 08 2024
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. Rated with 5 out of 5 stars.
Very useful companion that should be beside every 3D printer
This was my first purchase of any build plate adhesion promotor. I was skeptical about this things and looked at them as another way to pull extra money from my wallet. If I used right build plate and right temperature, my prints always sticked pretty well to the build plate and were easily released after cool down.
Since it was relatively cheap and had good reviews I decided to give it a try. If anything, just out of curiosity.
Well, this thing works and works well. It supports laziness in some way, because it makes your selection of build plate surface material and build plate temperature less critical. In 90% cases with common materials, you do not have to tune your build plate temperature settings to be spot on.
It can be easily cleaned with methanol (maybe with other alcohols too, haven't tried).
Try not to spray it over your linear guides and other sliding elements if you spray directly on installed build plate, because it leaves thin layer of adhesive (as it is supposed to do), and you might run into problems after certain amount of careless spraying sessions.Was this rating helpful? (2) (0)
Magazine Articles:
Discover 3DJake:
-
Delivery in 3 business days.
More than 10.300 products
We deliver worldwide to
more than 40 countriesSecure payments
with SSL encryption technology
Rated with 3 out of 5 stars.
Amazing ASA adheasion, impossible cleaning using water or IPA
Had a nice adhesion with ASA on smooth PEI at 110°(could be lower I think), didn't release after cooldown but plastic scraper saved the day, much better than just satin sheet.
However, the spray was impossible to clean off with spraying 99,5% IPA, washing with a bit of soap or submerging in warm water. The only thing that worked was ACETONE and nor acetone is safe for all buildplates (safe for smooth PEI by prusa) nor it is something you normally use.