4 English reviews written for Extrudr DuraPro ASA Black
22 customer reviews in all languages
| 5 stars | | 32 | (74%) |
|---|---|---|---|
| 4 stars | | 6 | (13%) |
| 3 stars | | 1 | (2%) |
| 2 stars | | 2 | (4%) |
| 1 Stars | | 2 | (4%) |
Filter reviews:
-
Constantinos
October 07 2023
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. -
Brad
September 12 2021
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. Black ASA
Rated with 5 out of 5 stars.
I wanted a finish as matte as black ABS. This is good enough, though a bit glossier than the ABS I used. I don't know if different black ASAs or ABSs have different glossiness.
Was this rating helpful? (2) (0)
-
Jay
September 11 2021
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. Warps like hell
Rated with 1 out of 5 stars.
Warping on smooth/satin/textured sheets from Prusa.
Warps with 3D Lac and kapton tape and even in a heated enclosure.
Smells worse than ABS.
Total disappointment.Was this rating helpful? (2) (6)
-
Dan
July 19 2021
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. Prints real nice on glass
Rated with 5 out of 5 stars.
Prints real nice on an Ender 3 V2 with stock hotend & the glass side of the bed. Had no problems with warping or prints getting loose.
Printed at pretty much the same settings as the 3DJake niceABS
Hotend: 240c
Bed: 100c
Speed: 20mm initial / 50 mm/s (could probably crank this up to 70mm like the niceABS)
I do have an enclosure with an opening at the front near the bed.
Did not notice any stringing, has very little smell. Will be using this to print the hot-end parts for the EVA-3D systemWas this rating helpful? (3) (0)
DuraPro ASA
Rated with 5 out of 5 stars.
Excellent no complains !!!
Was this rating helpful? (0) (0)