Creality Air Purifier for Resin Printers

The Creality Air Purifier in the Resin Version is Creality’s first professional air purification system designed specifically for 3D printing and tailored to the requirements of SLA, DLP and LCD resin printers. The device combines powerful multi-stage filtration with smart touch control and a real-time air quality display, creating a noticeably cleaner and more pleasant working environment, especially where resin fumes and VOCs present a particular challenge.

Unlike conventional household air purifiers, the Creality Air Purifier is specifically designed to filter VOCs, fine particles and typical printing odours. Its 360° all-round intake concept quickly and evenly captures pollutants from the entire working area before they can spread throughout the room.

High-efficiency multi-stage filtration

According to the manufacturer, the carefully matched filter system removes up to 99.97% of airborne particles and VOCs. The individual filter stages work seamlessly together:

• G4 pre-filter: captures up to 95% of larger particles such as dust, fibres and plastic residue;
• H13 HEPA filter: removes 99.97% of particles from 0.3 µm on a generous filter surface, 1.5 m²;
• high-density activated carbon filter layer: approximately three times denser than standard activated carbon filters and specifically designed to absorb resin and plastic fumes;
• V-fold activated carbon filter: increased contact area for more intensive absorption of benzene, aldehydes and other chemical emissions;

Compared with the FDM Version, the Resin Version of the Air Purifier contains a reinforced activated carbon layer, approx. 1.4 kg, designed specifically for the typical VOCs produced during resin printing.

360° all-round purification with turbo airflow

A powerful motor delivers an airflow rate of up to 250 m³/h, suction power of 1700 Pa and air speed of up to 20 m/s. The well-designed all-round intake geometry ensures that pollutants are captured directly at the source and that the full filter capacity is used. According to the manufacturer, up to 98% of the filter surface is actively utilised.

Real-time PM2.5 display

Thanks to a dedicated sensor, the integrated display shows the current fine dust level, PM2.5, in real time. This lets you see at a glance how clean the air in your working area is and when purification performance is needed most. It also provides practical visual feedback on the device’s cleaning performance.

Smart touch control

The integrated control panel makes the Air Purifier easy to operate. Fan speed, operating mode and filter status can all be managed conveniently at any time. The well-designed user interface makes operation intuitive, even without technical knowledge.

Long filter service life

The filters are designed for efficient continuous operation:

• standard filter: up to 1,000 operating hours,
• V-fold activated carbon filter: up to 1,500 operating hours.

This reduces both running costs and downtime during maintenance.

Suitable for practically any resin printer

The Air Purifier can be flexibly positioned next to or underneath your resin 3D printer. Thanks to the plug-and-play setup, no complex installation is required. This also makes it ideal if you operate several printers at the same time.

Installing the exhaust hose

(1) If the diameter of your device’s exhaust port is ≤ 65 mm: slide the hose clamp over the exhaust hose. Then insert the exhaust hose into the adapter pipe and secure it by tightening the hose clamp.

(2) If the diameter of your device’s exhaust port is larger than 65 mm: wrap the exhaust hose with EVA adhesive tape to increase its outer diameter accordingly. You can then insert the hose into your device’s exhaust port.

(3) If your device does not have an exhaust port: first slide the hose clamp onto the exhaust hose, then place the hose over the adapter sleeve. Secure the connection by tightening the hose clamp. Finally, attach the other end of the hose to your device’s exhaust outlet.

Technical specifications: