Unfortunately we haven't tested this so we don't know for sure. I think it would not be a problem but because the extruder is only designed for printers where the extruder is on the left side, it might be difficult to reach the thumbscrew when you need to adjust the tension as aluminium profiles may be in the way.

Yes it will fit, no modifications are necessary besides what is mentioned in the installation guide: https://store.micro-swiss.com/pages/installation-instructions-for-micro-swiss-bowden-dual-gear-extruder This is really retraction settings in the slicer and the change in steps also possible in the slicer

It might not line up with the filament sensor properly.

The gear ratio is different so the steps would need to be changed but it should fit ok

8 questions in English for Micro-Swiss Bowden Dual Gear Extruder

28 Questions in different languages

Micro-Swiss Bowden Dual Gear Extruder - 1 pc

8 questions in English for Micro-Swiss Bowden Dual Gear Extruder

28 Questions in different languages

Buy product

Filter questions and answers:

Hello, do I need to change the motor from my CR6-SE to work with Extruder??? (I already printed the 2mm support to align it with the material detector) Anything else? Thanks !

This question has not been answered yet.
Would this be suitable for use on a Geeetech A30T

This question has not been answered yet.
Is this extruder compatible with the fsun SR? Thanks in beforehand

This question has not been answered yet.
is this compatible with makerbot replicator 2?

This question has not been answered yet.
Will this fit my anycubic chiron

1 Answer, last answered on September 02 2022
- Andrew
  
  September 02 2022
  
  Customer Service
  
  Unfortunately we haven't tested this so we don't know for sure. I think it would not be a problem but because the extruder is only designed for printers where the extruder is on the left side, it might be difficult to reach the thumbscrew when you need to adjust the tension as aluminium profiles may be in the way.
Can this be fitted on a Creality Ender 3 v2. If yes, does it need any modification?

1 Answer, last answered on June 08 2022
- Andrew
  
  June 08 2022
  
  Customer Service
  
  Yes it will fit, no modifications are necessary besides what is mentioned in the installation guide: https://store.micro-swiss.com/pages/installation-instructions-for-micro-swiss-bowden-dual-gear-extruder
  
  This is really retraction settings in the slicer and the change in steps also possible in the slicer
Would this fit the Creality CR 6 SE please

1 Answer, last answered on March 29 2022
- Andrew
  
  March 29 2022
  
  Customer Service
  
  It might not line up with the filament sensor properly.
Would this fit onto a Anycubic vyper is the gearing the same

1 Answer, last answered on March 10 2022
- Andrew
  
  March 10 2022
  
  Customer Service
  
  The gear ratio is different so the steps would need to be changed but it should fit ok