6 English reviews written for 3DJAKE ASA Black
41 customer reviews in all languages
| 5 stars | | 56 | (72%) |
|---|---|---|---|
| 4 stars | | 10 | (12%) |
| 3 stars | | 8 | (10%) |
| 2 stars | | 1 | (1%) |
| 1 Stars | | 2 | (2%) |
Filter reviews:
-
-
Wouter
November 09 2023
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. 3DJake ASA black
Rated with 3 out of 5 stars.
Material prints very nice and looks beautiful. But the deeper the spool gets the more knots. I was able to save a few prints when i was around the printer. But had a few prints fail when i was not around. Ill try to rewind the spool, hope i can fix this issue with this.
Was this rating helpful? (0) (0)
-
Jimmers
May 24 2023
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. Love this stuff
Rated with 5 out of 5 stars.
I've only printed one spool but any time I need to print something functional this comes out - Magnetic handle for my telescope? Fusion360, some of this ASA, 5 hours later, perfect. Bespoke ramp over a door frame? 22 hours later, perfect ramp! No warping if I'm not lazy and looks great to boot.
Was this rating helpful? (0) (0)
-
Oleg
November 19 2022
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. This is now my go-to material.
Rated with 5 out of 5 stars.
Prints surprisingly good, with good adhesion, stiffness and low warping.
Can even print decorative things on minimal cooling and hotend temperatures typical to PLA, only at the cost of layer adhesion.Was this rating helpful? (1) (1)
-
Weak properties
Rated with 3 out of 5 stars.
This Asa filament (Light Grey) has very nice prints, smooth, no stringing, in my opinion more than suitable for design print even without need of aceton smoothing. But it is very soft to use for any technical appliance that needs strenght, compared to any other ASA or ABS brands. I'll keep it just for print Ing figures and stuff like that but thats's it.
Was this rating helpful? (1) (0)
-
Adam
May 12 2020
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. No good
Rated with 1 out of 5 stars.
This ASA is the worst Ive ever used. It was extremely prone to warping and splitting. I tried removing moisture more than once in a convection oven with no improvements. In addition the spool it came on had a triangular centre and not round which makes it very hard to avoid tangles because the spool jumps when turning. When the spool is 2.3kg its not practical to put the roll on bearings.
Was this rating helpful? (4) (1)
3D Jake ASA
Rated with 3 out of 5 stars.
Warps more than other brands of ASA. I need to print it very hot to avoid warping issues, even on small parts: 260 degrees nozzle and 110 degrees bed (which is outside the recommended parameters).
I print in an enclosure which I heat up before printing to ~35 degrees, but even then I get severe warping at 255 degrees nozzle and 100 degrees bed.
Was this rating helpful? (0) (0)