4 English reviews written for BROZZL All Metal Hot-End Upgrade Kit for Ender & CR-10
14 customer reviews in all languages
5 stars | | 19 | (65%) |
---|---|---|---|
4 stars | | 3 | (10%) |
3 stars | | 2 | (6%) |
2 stars | | 1 | (3%) |
1 Stars | | 4 | (13%) |
Filter reviews:
-
-
Brozzl comparable to MicroSwiss
Rated with 5 out of 5 stars.
I have both hotends from Brozzl and MicroSwiss. The Brozzl one works excellent with .4 and .6 nozzles with PLA and PetG on an ender 5 with a chemical coated glass bed. This hotend when built correctly with a direct drive does the job for me. I recommend it as a key upgrade and move away from bowden BS solution...
Was this rating helpful? (4) (0)
-
Brozzl hot end
Rated with 2 out of 5 stars.
Looked very well made but after running for a few hours it started to block. Using pla. Tried to fix the problem a few times but in the end fitted a new standard hot end so was a bit of a waste of money, sadly.
Was this rating helpful? (9) (4)
-
Major disappointment
Rated with 1 out of 5 stars.
This should have been a really good addition to the Ender 3 but it has given nothing but trouble. As with all bad engineering the devil is in the detail. As supplied neither the heat break nor the nozzle were properly secured and the head leaked. The nozzle itself is so large that the tip chills when operating with stock Ender 3 cooling and it is prone to clogging. The screw lock on the heat break is hopeless and you can't change a nozzle without removing the fan shroud so that you can hold the heat block with a spanner. The final straw was my doing, trying to get around the dodgy heat break grub screw I broke off a nozzle in the heat block. Now the whole assembly is a write off and I managed to get precisely 0 useable prints out of it.
Was this rating helpful? (11) (2)
Brozzl hot end
Rated with 5 out of 5 stars.
Purchased this to replace a stock Creality hot end on an ender 5. Installation was quick and easy, even for a novice and it works perfectly.
Was this rating helpful? (1) (0)