Lumber Jake PLA

Rated with 5 out of 5 stars.

I was keen to try a wood filament, i had heard that it can look bad and its all a hoax. I ordered some as I wanted to form my own opinion. I print using an Ender 3 Pro using all standard parts. I have to say that this filament prints really well, I especially like the fact that when you print slow and at a high quality setting, you can't see layer lines. The colour and texture almost seemed like industrial cardboard. I planned on spraying my parts then sanding a little to cause a distressed look and it handles really well. I didn't experience any stringing though I had little blobs here and there with wasn't an issue as the material comes off very easily. It does absorb oils which is nice if you plan to stain, just takes a little longer. Oddly, the thing I liked the most is that when you print with this filament there a smell of slightly burnt wood, a very nice smell. Over all I would say its a fantastic product I'd give it a 4.5 out of 5

Was this review helpful? Yes (2) No (0)