7 English reviews written for Phaetus Dragonfly Hotend BMS
39 customer reviews in all languages
5 stars | | 61 | (74%) |
---|---|---|---|
4 stars | | 10 | (12%) |
3 stars | | 3 | (3%) |
2 stars | | 1 | (1%) |
1 Stars | | 7 | (8%) |
Filter reviews:
-
-
Dragonfly Hotend BMS
Rated with 5 out of 5 stars.
exellent
Was this rating helpful? (1) (2)
-
Dragonfly Hotend BMS
Rated with 5 out of 5 stars.
Very pleased with this hotend. I am getting some very good results in my Creality 3D V2
Was this rating helpful? (2) (0)
-
dragonfly
Rated with 1 out of 5 stars.
I bought this item as a drop in replacement for an ender 3, i have tune a replaced lots for parts to try to get this hotend to print well to no avail. 3d jake say its a temp issue but i'm unable to get prints as good as the stock hotend. Not happy as 3djake has no idea as to what the problem is or how to fix it. I will be returning this item.
Was this rating helpful? (1) (12)
-
4 Monate Dauereinsatz
Rated with 5 out of 5 stars.
Habe mir das Hotend für meinen umgebauten Ender 5pro mit Direct-Drive geholt. Von der ersten Minute bin ich sehr zufrieden. Kein Verstopfen und mit 60W Heizpatrone bin ich sehr schnell und Präzise unterwegs. FW angepasst und auf 350°C ausgelegt neuen Termistor und siehe da ASA lässt sich deutlich besser drucken. PC macht nun deutlich mehr Spaß. In Sache Düse mache ich keine Versuche mehr nur Orginal dann läuft das.
Was this rating helpful? (2) (6)
-
ender 3 v2
Rated with 5 out of 5 stars.
very good and straight forward to install. very happy
Was this rating helpful? (2) (0)
-
Amazing machining
Rated with 5 out of 5 stars.
The machining is very precise. Even when holding it you sense the quality.
Very nice.Was this rating helpful? (2) (0)
good but not perfect
Rated with 4 out of 5 stars.
I never had trouble with it. The FullMetal Heatbreak is amazing. it is easy to change the nozzle and to cleanup too.
BUT: the width is 26mm and a lot of fanduck are to small.
Idem for the level of the nozzle to high and the fan event may touch the bed. I needed to modify the satsana fanduck.
I use this hotend with Ender 3 and a Micro-Swiss direct-drive extruder.
Was this rating helpful? (1) (0)