3DJAKE Hall-E Endstop (3-5 Volt)

A Hall effect end switch

This item is no longer being offered by the manufacturer
  • Exact setting possible

Similar products:

Creality Push-Fit
Antclabs BLTouch Levelling Sensor
Antclabs BLTouch Extension Cable SM-DU

Product information & technical details

Manufacturers: 3DJAKE

Description

The Hall Effect Endstop triggers the printer shaft to reach the home or end position by means of a magnetic sensor.

Therefore, a magnet (e.g. D = 4 mm, H = 1 mm) must be provided, which draws the sensor in.

The orientation is of importance => test first. The sensor provides an analog signal that is proportional to the magnetic flux density and compared with a pre-set valued (via a potentiometer). The advantage is that the adjustment of the operating position is significantly more sensitive using a potentiometer, than most mechanical constructions.

English reviews written for 3DJAKE Hall-E Endstop (3-5 Volt)

Did you know?

It is already possible to create prints using materials such as titanium, ceramics, wood, and many more.